Electrical
Power Supply:
22-30VDC,??????????? 150mA.
Galvanic isolation
Frequency Response (-3dB):
Nominal frequency: ??? 4 ~ 3.0KHz
Low frequency: ? 0.5 ~ 100Hz
Proximity probe Interface:
Sensitivity:
5mm and 8mm probe:?? 8 mV/um (200 mv/mil)
11mm probe: ???????? ????4 mv/um (100 mv/mil)
25mm probe: ???????? ????2mv/um (50 mv/mil)
Buffered Output:
Original, un-filtered signal
Impedance: ?????????????????????????? 150?
Maximum cable distance: ? 300m (1000ft)
Sensitivity: ??????????????????? same as the sensor
Local BNC connection and terminal block
S0 and S1 options:???? Source, Non isolated
S2 and S3 options:
Passive, Galvanic isolation, 1000VDC
Power supply range: 22-30VDC
4-20mA Output:
Dual 4-20mA, sourced (loop power not required)
Maximum load resistance:?? 380?
Alarm Setup:
0 ~ 100% FS.
Accuracy: ?? ?0.1%.
Delay:????????? 1~60s, according to 1 second increase, default is 3s. Speed monitor without delay.
Relays:
Seal: ??????????? Epoxy
Capacity: ??? 0.2A/240VAC, 0.4A/110VAC or
2.0A/24VDC, resistive load
Relay type: SPTD
Isolation: ???? 1000VDC
LED Machine Condition Indicator:
OK: ???? System OK indication
ALT: ?? Vibration over ALERT level
DNG: ? Vibration over DANGER level
BYP: ?? System in BYPASS
TRX: ?? Digital Transmission Active
RESET/BYPASS
Trip Multiply:
Double Multiply or Triple Multiply set in DTM-CFG
Short Trip/Multi terminal to COM terminal
System alarm level will increase by a factor of 2 or 3 (DTM10-201 / 301 only)
Modbus:
RS485 Modbus RTU
Not isolated (use DTM96 for isolation)
Local push button programming:
Alert and danger set-point, ZERO calibration
Software programming (DTM-CFG):
Digital condition monitoring (optional)
Physical
Dimension:
Height: ??????????????? 75mm (2.95?)
see figure below
Weight: ?????????????? 0.9lb (0.4kg)
Environmental
Temperature:
Operation: ? -40?? ~ +85?
Storage: ????? -50?? ~ +100 ?
Humidity: ???????? 90% non-condensing
Case: ?????????????? Aluminum